A4 (B8 Platform) Discussion - Intermittent Start Issue - Hi All - I recently purchased a 2010 Audi A4 2.0 Supreme Plus. Absolutely love this car. I just recently had the oil changed at the dealership and everything came back good upon the basic inspection. However, a couple of days ago, after purchasing it, I was
Received 543 Likes on 452 Posts. Agree, all Q7's develop parasitic drain issues from the door handle sensors/buttons over time. Rather than open up the door panels to cap' the wiring off/disconnect wiring, many owners choose to hardwire a small electronic trickle charger onto the car to maintain the battery, and there are threads on that you
It excepted the recode and the engine began running much more smoothly and the vacuum pump stopped running full time but the fan continued to run. I cleared the DTCs and ran the test again and now I have a: Address 01: Engine Labels: 079-907-560-BAR.clb. Control Module Part Number: 4L0 910 560 C HW: 4L0 907 560 A. However, if these sensors are working, but the start stop system has worked out that stopping the engine would be a bad idea, then the engine will not stop, and you will get a little crossed-out A symbol appear on the dash. You won't know why the start-stop system is not stopping the engine, just that it has decided not to stop the engine.mwiley. My 2008 audi q7, has an issue starting and if it starts also just dies randomly. It has the check engine light on, esp light blinking and abs solid light. We have replaced the Crankshaft and camshaft position sensors, Mass airflow sensor, Valve cover and gasket, fuel pump, battery and brake pads/sensors and rotors, lastly have checkedxBpMU.